Replacing The Pit Electronics In A Walthers 130' Turntable

Replacing The Pit Electronics In A Walthers 130' Turntable

Turn the new pit upside down and loosen the four screws at the center of the pit.

Make sure the plastic channel is free to move. The channel runs along the bottom of the pit and holds the wires that connect to the sensor.

Turn the pit right side up and push the sensor housing out of the wall in the pit.

Turn the pit upside down and remove the round plastic housing that holds the fingers.

Be careful not to pull the wires off of the sensor or fingers when handling the sensor.

When installing the new electronics in the old pit, hold the round plastic housing in place and tighten the screws half way.

Insert the plastic channel under the round housing. Make sure it can move freely.

Next, push the sensor housing into the opening in the wall of the pit. There’s a ledge on the front of the sensor housing. Sometimes it is a tight fit so take your time.

After reinserting the new sensor make sure the housing is flush with the inside wall and the bottom of the pit.

Tighten the screws.